Rigol MC3065 Instrument Options – DMM Module for M300 DAQ System

Description

DMM Module
MC3065 DMM Module
For M300 DAQ System

Rigol MC3065 DMM Module for M300 DAQ System.MC3065 (DMM Module):The DMM module is used to measure the signals under test and has 6 digit reading resolution. The measurement
functions include DCV, ACV, 2-wire resistance, 4-wire resistance, frequency, period, temperature and any sensor.Note: After connecting the DMM module, make sure that the signal
under test connected to the analog bus is no greater than 300 Vdc or 300 Vrms.Measurement Connections Using External Terminal BlocksM300 provides 6 kinds of terminal blocks to
easily connect the signal to be measured to the module. The models of the terminal blocks and corresponding modules are listed in the table below. This section introduces how to
use the external block. Terminal Block Module 1 M3TB32 MC3132, MC3232 2 M3TB64 MC3164, MC3264 3 M3TB24 MC3324 4 M3TB48 MC3648 5 M3TB16 MC3416 6 M3TB34 MC3534Note: for the
MC3724, the signal can be connected to the SMB connectors on the module directly. No terminal block is needed.WARNING: Cut off all the power supplies before opening the terminal
block or removing the terminal block from the module.1.Place the terminal block with the front (with the RIGOL caption) facing downward and pull the two latches in the arrow
direction in the figure below and press them down. Place the terminal block with the front facing upward and pull the upper cover of the terminal block upward and remove
it.2.Connect the cables for connecting the signal under test according to the labels on the circuit board of the terminal block (for the connecting method, refer to Table 1-1).
Pass the binding wires through the two groups of holes as pointed out by the arrows in the figure below to fix the cable connected. Pay attention to the channel or terminal
connected to the cable to ensure that